HP DL560 ProLiant DL560 Server Maintenance and Service Guide - Page 24
Hot-Plug Power Supply
UPC - 808736876919
View all HP DL560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
24 HP ProLiant DL560 Server Maintenance and Service Guide 3. Remove the tape drive blank. a. Reach underneath and squeeze the middle of the tape drive blank (1). b. Pull the blank out of the bay (2). 4. To replace the blank, slide the blank into the bay until it locks into place. Hot-Plug Power Supply To remove the component: 1. Unlock the hinge on the cable management arm and swing the arm away from the power supply area. 2. Determine how many hot-plug power supplies are installed: − If only one hot-plug power supply is installed, power down and remove the power cord from the server ("Powering Down the Server" on page 16). − If more than one hot-plug power supply is installed, continue with the next step. CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with either a component or a blank.