HP DL560 ProLiant DL560 Server Maintenance and Service Guide - Page 26

Power Supply Blank

Get HP DL560 - ProLiant - 1 GB RAM PDF manuals and user guides
UPC - 808736876919
View all HP DL560 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

26 HP ProLiant DL560 Server Maintenance and Service Guide 2. Slide the power supply into the power supply bay. 3. Connect the power cord to the power supply. 4. Route the power cord through the cable management arm or power cord anchor. NOTE: If using the power cord anchor, be sure to leave enough slack in the power cord so that the redundant power supply can be removed without disconnecting the power cord from the primary power supply. 5. Lock the cable management arm into the operating position. Power Supply Blank To remove the component: 1. Unlock the hinge on the cable management arm and swing the arm away from the power supply area. CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with either a component or a blank. 2. Remove the power supply blank. To replace a power supply blank:

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
26
HP ProLiant DL560 Server Maintenance and Service Guide
2.
Slide the power supply into the power supply bay.
3.
Connect the power cord to the power supply.
4.
Route the power cord through the cable management arm or power cord
anchor.
NOTE:
If using the power cord anchor, be sure to leave enough slack
in the power cord so that the redundant power supply can be removed
without disconnecting the power cord from the primary power supply.
5.
Lock the cable management arm into the operating position.
Power Supply Blank
To remove the component:
1.
Unlock the hinge on the cable management arm and swing the arm away
from the power supply area.
CAUTION:
To prevent improper cooling and thermal damage,
do not operate the server unless all bays are populated with either a
component or a blank.
2.
Remove the power supply blank.
To replace a power supply blank: