HP HP-380467-003 Getting Started Guide - Page 56
Placing a peripheral device on the, multi-storage bay top
UPC - 846084030171
View all HP HP-380467-003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Placing a peripheral device on the multi-storage bay (top) To use the chassis top to place a peripheral device, do the following: 1 Open the bay cover (A). Hold the cover on each side near the hinges, then lift the cover and slide it toward the back of the chassis (C). Gently lift it off. 2 Grasp the tab (T) and pull it out toward the front of the chassis (E). Put the tab in its storage area in the bay near the spindle (F). 3 Thread the data and power cables for the device through the cable tunnel opening at the back of the bay. Place the cables in the tab opening and replace the bay cover. Close the cover. 4 Connect the cables to the device and place it on top of the chassis (G). Connect the data cable to the USB or FireWire (IEEE 1394) connector on the back of the PC. Plug the power cord for the peripheral device into a power outlet. 50 Getting Started Guide