HP Integrity Superdome SX1000 Internal Cabling Guide for HP Smart Array Contro - Page 21
Dual Partition Configurations, RAID Cabling for IO Chassis 0 (Top Left and Top Right Hot Plug Hard Drives)
View all HP Integrity Superdome SX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Cabling for the HP Integrity rx8640 Server Dual Partition Configurations Dual Partition Configurations This section gives instructions for the installation of a second Smart Array Controller Card into the server. This will provide a dual partition configuration in the server. Figure 2-4 shows the correct cabling for a dual partition configuration, as viewed from the front of the server. Figure 2-4 Smart Array Controller Card with Dual Partition Cabling Mass Storage Backplane Connections RAID Cabling for IO Chassis 0 (Top Left and Top Right Hot Plug Hard Drives) To set up the RAID cabling on the top left and top right hot plug hard drives, do the following: Step 1. Verify that the HP Smart Array controller card is installed in PCI slot 8 of the IO Chassis 0. Step 2. Retrieve two cables from the cable kit (A7027-63001). Step 3. Identify the new cables using the colored cable ties which are also contained in the cable kit. For each cable, use two of the same color, one on each end. NOTE One end of each cable has a pull-tab connected to the SCSI connector which is labeled "This Connector to PCI Card". This end of the cable connects to the HP Smart Array card. Step 4. Plug the end of one of the cables with the pull-tab into the SCSI connector Port A2 on the Smart Array card (Port 1 is near the rear of the server). Repeat for SCSI connector Port A1 (Port 2 is near the center of the board). Chapter 2 17