HP StorageWorks 4000s NAS 4000s and 9000s Installation Guide - Page 25
Procedure
View all HP StorageWorks 4000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Template date: 09/2003 DRAFT Procedure To initialize the NAS device: 1. Connect the Ethernet cables to the respective network ports of the NAS device and the corresponding network segments. 2. Go to the NAS device and power it on. It will be several minutes before the NAS device is accessible on the network. Note: The NAS device will respond when the NAS operating system has started. 3. Open Internet Explorer on the PC. Enter https://, the serial number of the NAS 2000s followed by a hyphen (-), and then :3202. Press Enter. Example: https://D4059ABC3433-:3202 Note: Substitute the server name for the serial number if a server name was previously set. 4. Click Yes in the Security Alert dialog to accept the security certificate. 5. Login to the WebUI. This launches the WebUI configuration application (Rapid Startup) on the target HP StorageWorks NAS device, as shown in Figure 4. Note: The default login for the WebUI is Administrator and the password is hpinvent. The WebUI uses the same login as the local administrator's account or an account with administrative privileges. 6. Go to the next section "Rapid startup wizard configuration," to complete the setup procedures. NAS 4000s and 9000s Installation Guide 25 HP Restricted