HP StorageWorks 4000s NAS 4000s and 9000s Installation Guide - Page 34
Introduction to establishing a NAS cluster, Checklists for cluster server installation
View all HP StorageWorks 4000s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
DRAFT Introduction to establishing a NAS cluster The SAN connection tool must be completed and all the necessary software components for connecting to the desired storage must be installed before the configuration of cluster services. It is required that at least one LUN has been presented for the configuration of the Quorum disk. This LUN must be created from shared storage and must be at least 50 MB (500 MB is recommended). Additional LUNS may also be presented for use as shared disk resources. Note: The version of Storage Manager (Quota Management software located under the Shares tab) that comes installed on the StorageWorks NAS is not supported in a cluster. It must be uninstalled prior to creating the cluster. The SRM uninstall tool is located in the Cluster Installation Guide under the Cluster tab in the WEBUI. Once cluster installation has been completed, follow the procedure for software updates later this chapter under the heading "HP StorageWorks NAS software updates" on page 44. This must be done after the cluster install is complete. It is necessary to run this tool on all cluster nodes. Checklists for cluster server installation This checklist assists in preparing for installation. Step-by-step instructions begin after the checklist. Template date: 09/2003 34 NAS 4000s and 9000s Installation Guide HP Restricted