HP StorageWorks 4000s NAS 4000s and 9000s Installation Guide - Page 26

Direct attach method, Requirements, Procedure

Get HP StorageWorks 4000s - NAS PDF manuals and user guides View all HP StorageWorks 4000s manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

Template date: 09/2003 DRAFT Direct attach method You can access the WebUI using a monitor, mouse, and keyboard directly attached to the NAS device. Requirements The following items are required to run the WebUI configuration application: ■ Monitor ■ Mouse ■ Keyboard Procedure To initialize the NAS device: 1. Connect the Ethernet cables to the respective network ports of the NAS device and the corresponding network segments. 2. Connect the monitor, mouse, and keyboard directly to the rear panel connectors of the NAS device. 3. Open Internet Explorer and click Yes in the Security Alert dialog to accept the security certificate. This launches the WebUI configuration application (Rapid Startup) on the target StorageWorks NAS device, as shown in Figure 4. If the WebUI does not launch connect to the LocalHost and login to the WebUI Note: The default login for the WebUI is Administrator and the password is hpinvent. The WebUI uses the same login as the local administrator's account or an account with administrative privileges. 4. Go to the "Rapid startup wizard configuration" on page 27 to complete the setup procedures. 26 NAS 4000s and 9000s Installation Guide HP Restricted

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
26
HP Restricted
NAS 4000s and 9000s Installation Guide
DRAFT
Template date: 09/2003
Direct attach method
You can access the WebUI using a monitor, mouse, and keyboard
directly attached to the NAS device.
Requirements
The following items are required to run the WebUI configuration
application:
■
Monitor
■
Mouse
■
Keyboard
Procedure
To initialize the NAS device:
1.
Connect the Ethernet cables to the respective network ports
of the NAS device and the corresponding network segments.
2.
Connect the monitor, mouse, and keyboard directly to the rear
panel connectors of the NAS device.
3.
Open Internet Explorer and click
Yes
in the
Security Alert
dialog to accept the security certificate. This launches the
WebUI configuration application (Rapid Startup) on the
target StorageWorks NAS device, as shown in
Figure 4
. If the
WebUI does not launch connect to the
LocalHost
and login to
the WebUI
Note:
The default login for the WebUI is
Administrator
and the
password is
hpinvent
. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
4.
Go to the “
Rapid startup wizard configuration
” on page 27 to
complete the setup procedures.