HP Surestore S10 Service and User Manual (Short- and Long-Wave) - Page 28
etc/ping <hub IP address>, etc/ping 15.43.214.13
View all HP Surestore S10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
4. Verify that the 10Base-T port is operating properly. Insert an ethernet cable that is connected to the LAN into the 10Base-T port, and verify that the 10Base-T status LED turns on. (The status LED may begin flashing.) 5. Set the hub IP address and configure the hub as described in chapter 3, RS-232 Interface Functions. 6. Verify the connection between the HP-UX server and the hub. At the management server where Fibre Channel Manager is or will be installed, execute the following command: /etc/ping Example: /etc/ping 15.43.214.13 Fibre Channel Manager requires HP-UX 10.20 or 11.0 on the management server. If you are unable to ping the hub, refer to If the Management Server Cannot Ping the Hub on page 78. 7. Unplug the hub. 26 Procedure 3: Verify Hub Operation