HP Vectra XA 5/xxx HP Vectra xA 5/XXX Series 5 Pc DESKTOP USER’S GUID - Page 60

3 The HP Setup Program Understanding the SETUP Program Setup Item IDE Device #01 IDE Device #11 IDE Devices Submenu (Configuration group) Default [2564 Mb] (None) Action Configure IDE drive 02. It is not recommended to connect a CD-ROM on a channel which already has an IDE hard disk drive. IDE Device #21 (None) IDE Device #31 (None) Translation method [Extended] Integrated Bus IDE adapters3 [Both (IRQ 14/15)] Select 'Standard' only if you are running a UNIX Operating System. Enables or disables the integrated IDE adapters. Each "IDE Device #" setup item above has a submenu with the following setup items. Type Cylinders4 Heads4 Sectors/Track4 Multi-Sector transfers4 [Auto] 2564 Mb 4969 16 63 16 Sectors Select 'Auto' (the default) for automatic hard disk drive detection. 'User' allows you to edit all the detected parameters. Set the number of hard disk drive cylinders. Set the number of hard disk drive heads. Set the number of hard disk drive sectors per track. Determines the number of sectors per block for multiple sector transfers. 32-bit I/O Transfer mode4 [Enabled] Fast PIO 4 Enables or disables 32-bit data transfer. Selects the hard disk drive transfer mode and data transfer rate. 1. This setup item has a submenu, which is explained in the second part of this table. 2. The device number shown here (0, 1, 2, or 3) is dependent on which IDE Device setup item is selected. 3. If an asterisk (*) appears in front of this value, then you will see the following message in the lower part of the screen: [*] = The device is disabled for security reasons. To enable it, use the Security/Hardware Protection menu. (Refer to the Hardware Protection submenu under the Security group.) 4. Only available if 'User' has been selected as the Type. 48 English