HP XM600 hp kayak xm600, installing and replacing hardware parts in your pc wo - Page 17
Removing and Replacing a PCI Accessory Card, HP Kayak XM600 Upgrades
View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installing and Replacing Hardware Parts in Your PC Workstation Removing and Replacing a PCI Accessory Card Removing and Replacing a PCI Accessory Card NOTE To remove or install an accessory card, complete the following steps: 1 Switch off the display and PC Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC Workstation's cover (refer to page 3 for instructions). 3 If you intend to: a Install an Accessory Card: Unscrew and remove the slot panel. Store it in a safe place. If the slot cover is tight, loosen the screws on the adjacent slots. b Replace an Accessory Card: Remove any cables connected to the accessory card. Remove the screw that holds the old card in place and carefully pull it out. Some cards may have preferred locations and special installation instructions detailed in their manuals. 4 Aligning the new card carefully, slide it into position, then press it firmly into the slot and tighten the retaining screw. 5 Install any other accessories before replacing the cover (refer to page 4). Reconnect all cables and power cords. HP Kayak XM600 Upgrades The HP Kayak XM600 has five 32-bit 33 MHz, 5 V PCI accessory card slots and one Universal AGP PRO slot on the system board. HP Kayak XU800 Upgrades There are five PCI accessory card slots: • Three 32-bit 33 MHz PCI slots 1, 2 and 5. • Two 64-bit 66 MHz PCI slots 3 and 4. The three 32-bit/33 MHz PCI slots accept 5 V PCI cards and Universal PCI cards (support for 3.3 V or 5 V), while the two 64-bit/66 MHz PCI slots supports 3.3 V PCI cards and Universal PCI cards (support for 3.3 V or 5 V). A universal compatible 32-bit 33 MHz accessory card can be installed in PCI slot 3 and 4, however both slots will only perform at 33 MHz. 17