HP XM600 hp kayak xm600, installing and replacing hardware parts in your pc wo - Page 33

Replacing the System Board, Removing the, System Board

Get HP XM600 - Kayak - 128 MB RAM PDF manuals and user guides View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Installing and Replacing Hardware Parts in Your PC Workstation Replacing the System Board Removing the System Board Replacing the System Board 1 Switch off the display and PC Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC Workstation's cover (refer to page 3 for instructions). 3 Remove the HP UltraFlow Airflow Guide (refer to page 5 for instructions). 4 To ease installation, place your PC Workstation on its side with the system board facing upwards. 5 Remove the PC chassis retaining bar. 6 Disconnect any cables attached to the system board. 7 Remove the main memory (on some models, remove the Memory Expansion Card), processor and any accessory cards from the old system board (described in this chapter). 8 Loosen the screw located on the rear panel near the AGP PRO slot. 9 Remove the system board, being careful not to damage the PC's rear panel connectors. 10 Unclip the retaining bracket from under the system board. This bracket must be re-installed on the new system board. š ž  33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the System Board
33
Replacing the System Board
Removing the
System Board
1
Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2
Remove the PC Workstation’s cover (refer to page 3 for instructions).
3
Remove the HP UltraFlow Airflow Guide (refer to page 5 for
instructions).
4
To ease installation, place your PC Workstation on its side with the
system board facing upwards.
5
Remove the PC chassis retaining bar.
6
Disconnect any cables attached to the system board.
7
Remove the main memory (on some models, remove the Memory
Expansion Card), processor and any accessory cards from the old
system board (described in this chapter).
8
Loosen the screw located on the rear panel near the AGP PRO slot
.
9
Remove the system board, being careful not to damage the PC’s rear
panel connectors.
10
Unclip the retaining bracket from under the system board. This bracket
must be re-installed on the new system board.