HP XM600 hp kayak xm600, installing and replacing hardware parts in your pc wo - Page 31

Replacing the Power Supply Unit, Removing the, Power Supply Unit

Get HP XM600 - Kayak - 128 MB RAM PDF manuals and user guides View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Installing and Replacing Hardware Parts in Your PC Workstation Replacing the Power Supply Unit Replacing the Power Supply Unit WARNING Hewlett-Packard does not support power supply upgrades. This information is provided to help you replace a defective power supply unit. For your safety, only replace with a power supply unit provided by HP support services. Removing the Power Supply Unit 1 Switch off the display and PC Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC Workstation's cover (refer to page 3 for instructions). 3 Remove the HP UltraFlow Airflow Guide (refer to page 5). 4 Remove all internal power supply connectors. 5 Place your PC Workstation on its side with the system board facing upwards. 6 Remove the two screws located on the rear of the chassis that secure the power supply unit in position. 7 Remove the screw located inside the PC Workstation at the top of the power supply unit. 8 Push the supply unit forward until it is clear of the guide rail. Slightly tilt it towards the system board, then remove it from the chassis. œ ñ 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Power Supply Unit
31
Replacing the Power Supply Unit
WARNING
Hewlett-Packard does not support power supply upgrades. This
information is provided to help you replace a defective power supply
unit. For your safety, only replace with a power supply unit provided by
HP support services.
Removing the
Power Supply Unit
1
Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2
Remove the
PC Workstation’s cover (refer to page 3 for instructions).
3
Remove the HP UltraFlow Airflow Guide (refer to page 5).
4
Remove
all
internal power supply connectors.
5
Place your PC Workstation on its side with the system board facing
upwards.
6
Remove the two screws located on the rear of the chassis that secure the
power supply unit in position.
7
Remove the screw located inside the PC Workstation at the top of the
power supply unit.
8
Push the supply unit forward until it is clear of the guide rail. Slightly tilt
it towards the system board, then remove it from the chassis.
æ