Homelite UTi2100 Operation Manual - Page 14

FEATURES PRODUCT SPECIFICATIONS ENGINE Engine Type 79cc OHV Replacement Spark Plug Torch A5RTC Engine Lubricant Volume 13.52 oz. GENERATOR Rated Voltage 120 V AC/12 V DC Rated Amps 14.1 A AC/7.5 A DC Rated Running Watts 1,700 W Starting Watts 2,100 W Rated Frequency 60 Hz KNOW YOUR GENERATOR See Figure 1. The safe use of this product requires an understanding of the information on the product and in this operator's manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all o­ perating features and safety rules. 120 V AC RECEPTACLES Your generator has two single phase, 60 Hz outlets that are 120 Volt AC, 15 Amp receptacles. These can be used for operating appropriate appliances, electrical lighting, tools, and motor loads. AIR FILTER The air filter helps to limit the amount of dirt and dust drawn into the unit during operation. AUTO IDLE SWITCH The auto idle switch is used to control the speed of the engine and conserve fuel. When the switch is in the ON (I) position and no appliances are connected to the unit, the engine will idle. If an appliance is added, the engine speed will increase to power the item. If the appliance is removed, the engine will return to idle. BATTERY CHARGING CABLE The battery charging cable makes it easy to charge 12 Volt lead acid batteries with the generator. NOTE: Only use battery charging cable to charge vented wet lead acid batteries. CARRY HANDLE The generator has a carry handle for easy transport. CHOKE LEVER The choke lever is used when starting the engine. DC CIRCUIT BREAKER The circuit breaker is provided to protect the generator against electrical overload. DC RECEPTACLE Your generator has a 12 volt, 7.5 Amp DC receptacle for charging lead acid batteries. WARNING: The 12 V DC receptacle is designed to charge vented wet lead acid batteries only. Other types of batteries could burst, causing personal injury and damage. FUEL TANK The fuel tank has a capacity of 1.3 gallon. NOTE: The fuel flows from the fuel tank to the carburetor only when the on/off switch is in the ON (I) position. GROUND TERMINAL The ground terminal is used to assist in properly grounding the generator to help protect against electrical shock. Consult with a qualified local electrician for grounding requirements in your area. LED DISPLAY LEDs provide feedback to indicate whether the generator is in use, overloaded, or in need of lubricant. LOW OIL SHUT DOWN PROTECTOR The low oil sensor causes the engine to stop if the level of lubricant in the crankcase is insufficient. OIL CAP/DIPSTICK Remove the oil fill cap to check and add lubricant to the generator when necessary. 10 - English