Homelite UTi2100 Operation Manual - Page 18

OPERATION STARTING THE ENGINE See Figures 7 - 11. NOTICE: On a level surface with the engine off, check the lubricant level before each use of the generator. NOTE: If location of generator is not level, the unit may not start or may shut down during operation. n Unplug all loads from the generator. n Open the vent on the fuel cap by rotating the fuel cap lever to the ON (I) position. n Put the auto idle switch in the off position. n Put the on/off switch in the ON ( I ) position. NOTE: When the on/off switch is in the ON (I) position fuel will flow from the fuel tank to the engine. n Pull the choke lever out to the start position. NOTE: If engine is warm, push the choke lever in to the run position. n Pull the starter grip and rope until the engine runs (a maximum of 6 times). NOTE: Do not allow the grip to snap back after starting; return it gently to its original place. n Allow the engine to run for 15 - 30 seconds, then push the choke lever in to the run position. NOTE: For quieter more efficient operation, place the auto idle switch in the on position. STOPPING THE ENGINE See Figures 7 and 9. n Remove any load from the generator. n Put the on/off switch in the OFF ( O ) position. n Close the vent on the fuel cap by rotating the fuel cap lever to the OFF (O) position. NOTE: If the temperature is above 75˚F, leave the vent on the fuel cap open to relieve pressure. To stop the engine in an emergency situation: n Put the on/off switch in the OFF ( O ) position. WARNING: While operating and storing, keep at least 3 feet of clearance on all sides of this product, including overhead. Allow a minimum of 30 minutes of "cool down" time before storage. Heat created by muffler and exhaust gases could be hot enough to cause serious burns and/ or ignite combustible objects. USING THE BATTERY CHARGING CABLE See Figure 12. WARNING: The 12 V DC receptacle is designed to charge vented wet lead acid batteries only. Other types of batteries could burst, causing personal injury and damage. NOTICE: The 12 V DC receptacle provides continuous charge. Do not overcharge battery or leave battery unattended. Doing so may cause damage to the battery. NOTICE: Do not use the generator to jump start vehicles. Doing so could result in damage to the vehicle or it's electrical components. n Place the auto idle switch in the off position. n Using the battery clamps, connect the battery charging cable assembly to the battery terminal. Connect the red wire to the positive (+) terminal first, then connect the black wire to the negative (-) terminal. Make sure all connections are secure. NOTE: Be careful not to short across the terminals when installing. Shorting the terminals together can cause sparks, damage to the battery or generator, or even burns or explosions. NOTE: To prevent short circuit, keep away from a metal surface during clamp connection. n Connect the battery charging cable assembly to the 12 V DC receptacle. n Start the generator. NOTE: The AC receptacles can be used while the DC receptacle is in use. n The battery will become slightly warm to the touch while charging. This is normal and does not indicate a problem. NOTE: Only use battery charging cable assembly to charge vented wet lead acid batteries. n When batteries become fully charged, disconnect the battery charging cable assembly from the battery. Disconnect the negative (black) wire first, then the positive (red) wire, being careful not to short across the terminals. Always abide by the safety warnings provided with the battery. 14 - English