Hoover S3670 Manual - Page 11
Powered hand tool, Agitator brush roll, replacement - hose
UPC - 073502029046
View all Hoover S3670 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Powered hand tool Agitator brush roll replacement When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part no. 48414088. 3-21 A 3-22 B 2. Unscrew the two Philips screws and remove belt guard (B). How to replace Disconnect cleaner from electrical outlet. 1. Remove tool from hose and turn it so bottom faces up. Press the latches on either side of tool and remove bottom plate (A). 3-23 D C 3. Remove agitator including end plates (C) and discard. 4. Inspect belt to ensure that it is in good condition. If belt is cracked, gouged or broken, replace it (see following section). 5. Insert brush roll through belt and position belt over gear teeth (D) on brush roll. 3-24 3-25 3-26 B A C E 6. With curved ends down, slide end plates (C) of brush roll into slots (E) on tool. 7. Replace belt guard (B) making sure not to pinch brush bristles in guard. Turn agitator, making sure it rotates freely. Replace and tighten screws. 8. To replace bottom plate (A), insert the four tabs on edge of bottom plate into slots on front of tool. Pivot bottom plate down and snap closed. 11