Hoover S3670 Manual - Page 12

Powered hand tool Belt replacement Inspecting the belt The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt is cracked, gouged or broken, it should be replaced. 3-27 The belt can be seen through the top of the nozzle or by removing the bottom plate and belt guard (Figs. 3-21 and 3-22). 3-28 F 3-29 E Replacing belt When replacing belt, ask for HOOVER part no. 38528037. 1. Remove bottom plate, belt guard and brush roll as described in Figs. 3-21 through 3-23. 2. Grasp turbine (E) and pull firmly to remove. 3. Remove belt from turbine pulley (F). Replace with new belt. H G 4. With flat sides of turbine retainers (G) pointing down, slide retainers into grooves (H) on both sides of tool housing and snap into place. 5. Replace brush roll, belt guard, and bottom plate as described in Figs. 3-23 through 3-26. Lubrication The motor is equipped with two bearings that contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing. The agitator brush roll is equipped with two ball bearings that should be lubricated periodically by a Hoover Factory Service Center or an authorized Hoover Warranty Service Dealer (Depot). Service To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by: • checking the Yellow Pages under "Vacuum Cleaners - Household" OR • calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) OR• checking the Service section of Hoover, Inc., online at www.hoover.com Please do not send your cleaner to The Hoover Company in Glenwillow for service, this will only result in delay. If further assistance is needed, contact Hoover, Inc., Consumer Response Center, Glenwillow, Ohio 44139, Phone: 1-800-263-6376 Mon-Fri 8AM-7PM EST. In Canada, contact Hoover Canada, Etobicoke, Ontario M8W 3R9, Phone: 1-800-263-6376 Mon-Fri 8AM-7PM EST. Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.) 12