Husqvarna AUTOMOWER 550 EPOS Owner Manual - Page 12
Introduction - Installation
View all Husqvarna AUTOMOWER 550 EPOS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3 Installation 3.1 Introduction - Installation WARNING: Read and understand the safety chapter before you install the product. CAUTION: Use original spare parts and installation material. Note: Refer to www.husqvarna.com for more information about installation. 3.2 Primary components for installation The installation includes the components that follow: • Robotic lawn mower, that cuts the lawn automatically. • Charging station, that charges the product. • Power supply, which is connected to the charging station and a 100-240V power outlet. • Reference station4, that receives satellite signals and sends correction data to the robotic lawn mower. • Mobile device with the Automower® Connect app to do the installation and the settings for the product. 3.3 General preparations CAUTION: Water filled holes in the lawn can cause damage to the product. CAUTION: Read the installation chapter before you start the installation. • Make a blueprint of the work area and include all obstacles. This makes it easier to examine where to put the charging station, the reference station, and the virtual boundaries. • Make a mark on the blueprint where to put the charging station, the reference station, the point of interest, the transport paths and the virtual boundaries for the work areas and stay-out zones. • Make sure that the work area where the product operates has unimpeded sky view. • Fill in holes in the lawn. • Cut the grass before you install the product. Make sure that the grass is maximum 10 cm / 4 in. Note: The first weeks after installation the sound level when cutting the grass can be higher than usual. The sound level will decrease when the product has operated for some time. 3.4 To examine where to put the reference station Read and understand the instructions about where to put the reference station. Refer to the Operator's manual for the reference station. 3.5 To examine where to put the charging station • Put the charging station in the work area or near the work area. A work area can be connected to the charging station with a transport path. • You can put the charging station in an Automower® house. • Keep a minimum 3 m / 10 ft. of free space in front of the charging station. • Put the charging station (A) were the docking point (B) has unimpeded sky view. This means that 110° of the sky in all directions must be unimpeded. The product cannot receive satellite signals that is less than 10% elevation angle. The charging station docking point (B) is 3 m / 9.8 ft. in front of the charging station. >110° 35° 35° 3 m A B >110° 60° 10° 3 m A B 4 Purchased separately. 12 - Installation 1576 - 003 - 30.12.2020