Husqvarna AUTOMOWER 550 EPOS Owner Manual - Page 15

3.8 Installation of the product 3.8.1 General steps for installation of the product For full instructions follow the installation instructions in Installation of the product on page 15. 1. Install the reference station. 2. Install the charging station. 3. Install the Automower® Connect app to your mobile device. 4. Pair the product with the Automower® Connect app. Do the basic settings in the start up sequence in the Automower® Connect app. 5. Make a map with work areas, stay-out zones, transport paths and point of interests. 6. Use Automower® Connect app to do settings for the product. 3.8.2 Installation tools • Hex key, 8 mm. Included in the carton. 3.8.3 Installation of the charging station Read and understand the instructions about the charging station. Refer to To examine where to put the charging station on page 12. WARNING: Obey national regulations about electrical safety. WARNING: The product is only to be used with the power supply unit supplied by Husqvarna. enclosure that is weatherproof with the attachment plug cap inserted or removed. CAUTION: Do not make new holes in the charging station plate. CAUTION: Do not put your feet on the baseplate of the charging station. WARNING: The power supply cable and extension cable must be outside the work area to avoid damage to the cables. When connecting the power supply, only use a power outlet that is connected to an residual current device (RCD). 3.8.3.1 To install the charging station 1. Put the charging station in the selected area. 2. Attach the charging station to the ground with the supplied screws. 3. Connect the low-voltage cable to the charging station. 4. Put the power supply at a minimum height of 30 cm / 12 in. Refer to To examine where to put the power supply on page 13. WARNING: Do not put the power supply at a position where there is a risk that it can become wet. Do not put the power supply on the ground. WARNING: Do not encapsulate the power supply. Condensed water can harm the power supply and increase the risk of electrical shock. WARNING: Risk of Electric Shock. Install only to an residual-current device (RCD) with a tripping current of maximum 30 mA when connecting the power supply to the wall socket. Applicable to USA/Canada. If power supply is installed outdoors: Risk of Electric Shock. Install only to a covered Class A GFCI receptacle (RCD) that has an min 30 cm / 12" 5. Connect the power supply cable to a 100-240V power outlet. 6. Put the low-voltage cable in the ground outside the work area. Use stakes or bury the cable. 7. Put the product in the charging station to charge the product. 3.8.3.2 To do a visual check of the charging station 1. Make sure that the indicator LED lamp on the charging station has a green light. 1576 - 003 - 30.12.2020 Installation - 15