Husqvarna AUTOMOWER 550 EPOS Owner Manual - Page 37

7 Transportation, storage and disposal 7.1 Transportation The supplied Li-ion batteries obey the Dangerous Goods Legislation requirements. • Obey all applicable national regulations. • Obey the special requirement on package and labels for commercial transportations, including by third parties and forwarding agents. 7.2 Storage • Fully charge the product. Refer to To charge the battery on page 24. • Disconnect the product with the Main switch. Refer to To switch off the product on page 24. • Clean the product. Refer to Clean the product on page 25. • Keep the product in a dry, frost free space. • Keep the product with all wheels on level ground during storage, or use a Husqvarna wall hanger. • If you keep the charging station indoors, disconnect and remove the power supply from the charging station. Note: If you keep the charging station outdoors, do not disconnect the power supply and the connectors. 5. Lift the rear edge of the top section of the chassis. 6. Disconnect the cable from the main circuit board. 7. Remove the top section of the chassis. 8. Remove the 3 screws that holds the batteries with a Torx 20. 7.3 Disposal • Obey the local recycling requirements and applicable regulations. • For questions about how to remove the battery, refer to To remove the batteries on page 37. 7.3.1 To remove the batteries CAUTION: Only remove the batteries when you dispose the product. When you remove the warranty seal, the Husqvarna warranty is no longer applicable. 9. Disconnect the batteries connection from the main circuit board. 1. Disconnect the product with the Main switch. Refer to To switch off the product on page 24. 2. Pull out the grommet on the charging cable at the very front of the product, and carefully remove the connector. 3. Lift the cover, one corner at a time. 4. Remove the 14 screws with a Torx 20. 1576 - 003 - 30.12.2020 Transportation, storage and disposal - 37