IBM 4800-741 Operation Guide - Page 88
Installing, character/graphics, display
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Updated October 31, 2007 5. Connect the other end of the display cable to any green (12 V) powered-USB port on the rear of the system unit. You can also connect the end of the display cable to the number 4 RS-485 port on the rear of the system unit. Installing the character/graphics display This section describes how to install a character/graphics display. You install the display post with either a snap or a base. Installing the display post with a snap To install the character/graphics display post with a snap to the POS terminal, follow these procedures: 1. Confirm that the character/graphics display filler is installed. A B Figure 63. Connecting the character/graphics display post 2. Connect the character/graphics display A to post B , as shown in Figure 63. 68 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Planning, Installation, and Operation Guide