IBM 4800-741 Operation Guide - Page 95
Installing, displays, wedge, mount
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Updated October 31, 2007 Installing CRT displays Note: The CRT can be mounted on either side of the system unit. However, if you installed a 4610 printer with MICR, mount the display on the left side to minimize the effect of magnetic interference from the CRT on the MICR reader in the printer. Cathode ray tube (CRT) displays can be mounted on a wedge or on a post. A wedge can be mounted on the system unit or distributed on the counter. Installing a CRT on a wedge mount This section describes how to install a CRT on a wedge mount. Figure 73. Wedge mount for CRT Figure 73 show the wedge mount for the monochrome CRT displays. Figure 74. Installing the power cord and video cable on a CRT wedge mount 1. See Figure 74 and place the CRT upside down on a table or counter. 2. Thread the power cord and video cable of the CRT up through the center of the mount. Chapter 4. Installing external options 75