IBM 4800-741 Hardware Service Guide - Page 80
Removing, memory, modules
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Updated July 14, 2008 Removing the memory modules 1. Follow the instructions in "Removing the covers" on page 29 to remove the front bezel and top cover. 2. Follow the instructions in "Removing the top plate" on page 32 to remove the top plate. 3. Follow the instructions in "Removing the air duct (Models 722, 74x, 78x, and C4x)" on page 44 to remove the air duct. 4. See Figure 53. Locate the memory modules and slots. 0 Figure 53. Opening the memory module latches 5. Press downward on the white tabs ( O ) on both sides of the memory-module connectors until they are both at a 45-degree angle. The memory module rises slightly in the connector. 6. Touching only the upper corners of the memory module, lift it gently until the module is free from the connector. To replace the memory modules, follow these instructions: 1. Note the alignment notches along the bottom of the module where it plugs into the connector. 62 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide