IBM 4800-741 Hardware Service Guide - Page 84
Removing, pull-out, handle, cable, guide
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Updated July 14, 2008 Removing the pull-out handle Follow these steps to install the pull-out handle: 1. Set the unit on a flat surface. 2. See Figure 17 on page 29 and follow the steps to remove the front bezel. 3. Slide the pull-out handle to the left of the clip and rotate as shown. Slide to the right to remove. Figure 57. Attaching the pull-out handle 4. To replace, align the handle to the clip at approximately a 45-degree angle. See Figure 57. 5. Place the pull-out handle on the clip and slide it to the right for a secure fit. Removing the cable guide Follow these instructions to replace the cable guide: 1. Pull the 4800 unit from the front of housing and place on a cart 2. Remove the velcro strap holding the cables. 3. Remove the screw holding the cable guide. 4. Remove the cable guide from the 4800 unit and also remove the cables. 66 SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide