IBM 4800-741 Hardware Service Guide - Page 91
Problem, determination
View all IBM 4800-741 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Updated July 14, 2008 Chapter 3. Problem determination Problems with the SurePOS 700 can be caused by software errors or hardware failures. This chapter contains problem-analysis tables to help determine the cause of a problem and how to solve it. When you power on the SurePOS 700, the system runs a power on self test (POST). A successful POST is indicated by: v A single beep v The power and UPS status indicators are both on and not blinking. If the POST is unsuccessful, see "Problem isolation" on page 74. Preliminary checklist If you have a problem with the SurePOS 700, first use the following checklist: 1. Make sure that all I/O devices are connected correctly. 2. Make sure that AC power is connected. 3. Make sure that the contrast and the brightness controls on the display are adjusted correctly. 4. Make sure that all installed hardware (such as a memory module, feature card, printer, or mouse) and cables are connected correctly and securely. 5. Power ON and listen for one or two beeps at the completion of the POST. 6. If POST does not complete, power OFF the SurePOS 700 and remove any optional adapters and all I/O devices except a single keyboard and display. 7. If POST still fails to complete, see "Problem isolation" on page 74. © Copyright IBM Corp. 2003, 2008 73