IBM 8482 User Manual - Page 77
Microprocessor and fan sink, Disconnect any cables that impede access to the microprocessor.
UPC - 000435244659
View all IBM 8482 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
To replace the power supply, reverse the previous steps, making sure to engage the hooks on the power supply to the slots on the chassis. Microprocessor and fan sink Note: v Read "Installation guidelines" on page 23. v Read the safety notices at "Safety information" on page 107. v Read "Handling static-sensitive devices" on page 24. Complete the following steps to remove the fan-sink assembly and the microprocessor: 1. Turn off the server and attached devices; then, disconnect all power cords and external cables. 2. Turn the server on its side so that it is laying flat, with the cover facing up. 3. Remove the cover and support bracket (see"Removing the side cover" on page 26 and "Removing and installing the support bracket" on page 28). 4. Disconnect the fan sink cable from the system board. 5. Disconnect any cables that impede access to the microprocessor. Note: The illustrations in this document might differ slightly from your hardware. Orientation indicators 6. Loosen the two captive screws on either side (in leaf spring enclosures) of the heat sink. 7. With the two captive screws loosened, pivot the leaf-spring assemblies outward and out of the notches on the fan-sink assembly. Chapter 6. Field replaceable units 67