Icom IC-78 Instruction Manual - Page 36
Extra Features
View all Icom IC-78 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
6 EXTRA FEATURES s INTRODUCTION Extra features, explained in this section, are available only on some versions of the IC-78. Therefore, the instructions in this section are not necessary for some versions. s VFO operation D Entering VFO mode To enter VFO mode, push [FC] for 1 sec. • VFO indicator appears. • In the VFO mode, channel comment cannot be indicated. [FC] D Tuning The transceiver has several ways of tuning for temporal operation as follows; • Tuning with the channel selector By rotating the channel selector, operating frequency changes in the desired tuning step, set in the quick set mode. (p. 30) This is the most convenient way when searching for signals around the pre-programmed frequency. • Tuning with the keypad Enter the frequency as follows. •Start Appears only when 1 Hz tuning step is selected. Changing digit; according to selected tuning step •To set to 25.118 MHz •To set to 706 KHz (0.706 MHz) •To set to 5.0000 MHz •To change 13.1430 MHz to 13.3190 MHz ¯ For duplex operation setting, push [TXF] then set the transmit frequency, after the receive frequency is set. 34