Icom IC-78 Instruction Manual - Page 44
Data cloning between transceivers
View all Icom IC-78 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
9 CONTROL COMMAND • Command table Command 00 01 02 03 04 05 06 08 0E 11 14 15 16 19 Sub command 00 01 - 01 02 03 01 02 02 22 44 00 Description Send frequency data Send mode data Read Upper/Lower frequencies Read frequencies Read operating mode Set operating frequency Set mode Set memory Set memory channel Scan stop Memory scan start ATT AF gain RF gain Squelch level Read squelch Open/Close Read S-meter level PREAMP Noise blanker Microphone compressor Read ID s Data cloning between transceivers • Data cloning The IC-78's data (programmed frequencies, channel comment, both quick and initial set mode conditions, etc.) can be copied to the other IC-78. This function is useful when exactly the same setting of the IC-78s is required. • Cloning operation q Turn power OFF. w Connects a mini-plug cable between two IC-78's (master and sub) [REMOTE] jack. t Push [TONE] of the master IC-78 to start cloning. Master transceiver indication [REMOTE] jack to [REMOTE] Mini-plug cable to other IC-78's [REMOTE] e While pushing [TXF] and [FC], turn the master IC78 power ON. r While pushing [SET] and [FC], turn the sub IC-78 power ON. Master transceiver indicates "M". Daughter transceiver indication • After cloning complete; y Turn power OFF Daughter transceiver indication 42