Icom IC-78 Instruction Manual - Page 4
Panel Description
View all Icom IC-78 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
2 PANEL DESCRIPTION s Front panel Speaker Function Display @1 @0 !9 !8 !7 !6 q !5 PWR !4 w !3 !2 e rt yu i o !0 !1 q POWER SWITCH [PWR] ¯ Push momentarily to turn power ON. • Turn the optional DC power supply ON in advance. ¯ Push for 1 sec. to turn power OFF. ¯ While pushing and holding [SET], push [PWR] to enter the initial set mode. (p. 28) w MICROPHONE CONNECTOR [MIC] Accepts supplied or optional microphone. • See p. 45 for appropriate microphones. • See p. 7 for microphone connector information. e HEADPHONE JACK [PHONES] (p. 11) Accepts headphones. •When headphones are connected, the internal speaker or connected external speaker does not function. u IF SHIFT CONTROLS [SHIFT] (outer control; p. 20) Shifts the center frequency of the receiver's IF passband. • Rotate the control clockwise to shift the center frequency higher, or rotate the control counterclockwise to shift the center frequency lower. i LOCK SWITCH [LOCK] (p. 14) Push momentarily to turn the dial lock function ON and OFF. • The dial lock function electronically locks the channel selector. o CHANNEL SELECTOR Selects an operating channel, sets conditions in the quick/initial set mode items, etc. r AF CONTROL [AF] (inner control) Varies the audio output level from the speaker. !0 PREAMP SWITCH [P.AMP] (p. 19) Push to turn the preamp ON or OFF. t RF GAIN/SQUELCH CONTROL [RF/SQL] (outer control; pgs. 15, 31) Adjusts the squelch threshold level. The squelch removes noise output from the speaker (closed condition) when no signal is received. • The squelch is available for all modes. • The control can be set as the squelch plus RF gain controls or squelch control only (RF gain is fixed at maximum) in initial set mode. y RIT CONTROL [RIT] (inner control; p. 19) ¯ Shifts the receive frequency ±1.2 kHz for clear re- ception of an off frequency signal. • Rotate the control clockwise to increase the fre- quency, or rotate the control counterclockwise to decrease the frequency. " " appears on the display. !1 FC SWITCH [CH] ¯ Push to change the indication, channel comment or stored frequency. (p. 14) This key action only for some versions. ¯ Push for 1 sec. to entering into VFO mode. (p. 35) !2 MEMORY CHANNEL UP/DOWN SWITCHES [√ DN]/[UP ∫] ¯ Push to select the operating channel. (p. 13) ¯ Push for 1 sec. to start scanning. (p. 14) ¯Push to select the quick/initial set mode items while quick/initial set mode is selected. (p. 28) ¯ Push to select the digit of channel comment while editing. (p. 27) 2