Icom ID-52A Basic Manual english - Page 56
About the DR function, Ways to Communicate with the DR function, IMPORTANT, Local Area call
View all Icom ID-52A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
INTRODUCTION IMPORTANT! Before starting D-STAR, the following steps are needed. STEP 1. Enter your call sign (MY) into the transceiver. (p. 45) STEP 2. Register your call sign (MY) to a gateway repeater. (p. 47) STEP 3. Enter your D-STAR equipment into your registration form. (p. 48) ► You have completed the steps!! ■■ About the DR function You can easily use D-STAR repeaters with the D-STAR Repeater (DR) function. With this function, you can select the preset repeater or frequency in "FROM" (access repeater), and Your call sign in "TO" (destination) on the DR screen, as shown below. zz To display the DR screen, hold down [DR] for 1 second. zz On the DR screen, pushing D-pad() selects "FROM" and pushing D-pad() selects "TO." NOTE: If the repeater set in "FROM" (Access Repeater) has no Gateway, you cannot make a Gateway call. Destination (Repeaters/Station) Access repeater The DR screen (Example) ■■ Ways to Communicate with the DR function With the DR function, the transceiver has 3 ways to communicate. Local Area call: To call through your local area (access) repeater. You can use an FM repeater. Gateway call: To call through your local area (access) repeater, repeater gateway, and the Internet to your destination repeater or individual station's last used repeater, using Call Sign Routing. Simplex call*: To call another station not using a repeater. * You can make a simplex call in the VFO mode. (p. 50) 43 D-STAR GUIDE