Invacare M91R Owners Manual - Page 62
Removing/Installing the Seat Assembly, Removing, Installing
View all Invacare M91R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
5 WHEELCHAIR OPERATION 5.10 Removing/Installing the Seat Assembly ƽ WARNING DO NOT store items under seat - interference with seat latch may result. For this procedure, refer to FIGURE 14 on page 63. This procedure is for wheelchairs without the Formula PTO Plus seating system only. For wheelchairs with the Formula PTO Plus seating system, refer to Tilting the Seat Assembly on page 64. Removing 1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 104. 2. Push down on the latch bar underneath front of seat. 3. Tilt front edge of seat up. 4. Slide the seat assembly forward to disengage seat from the pivot brackets located in the rear. Installing 1. Position the seat in the rear pivot brackets as shown in FIGURE 14. 2. Tilt front edge of seat down. 1. When seat is lowered, engage seat brackets into seat clevis pins. ƽ WARNING When reinstalling the seat verify that the seat brackets are engaged with the seat clevis pins by pulling up on the latch bar. 2. Pull up on latch bar to verify that brackets are engaged with seat clevis pins. 3. Connect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 104. Invacare® Pronto® M91™ 62 Part No 1143153