JVC HR-S5900U Instructions - Page 20

20 EN 1 2 3 2 4 5 6 7 7 8 9 0 4 1 3 6 7 INITIAL SETTINGS (cont.) Access DBS Receiver Brand Set screen 6 Press OK. Enter DBS Receiver's brand 7 Press the appropriate Number keys to enter the brand code from the DBS RECEIVER BRAND SET 4 0 following list, then press OK. The program currently received through the PRESS NUMBER KEY (0-9) THEN (OK) TO TEST PRESS (MENU) TO END DBS receiver appears for about 10 seconds. BRAND JVC (DISH Network) ECHOSTAR (DISH Network) PRIMESTAR SONY (DSS) RCA (DSS) CODE 51 51 50 41 40 ● If the DBS receiver's channel changes to the channel listed below for your brand, setting is complete JVC = 100 ECHOSTAR = 100 PRIMESTAR = 55 SONY = 205 RCA = 205 Press OK and "DBS DBS RECEIVER BRAND SET RECEIVER CONTROL IS ON" appears on the screen for about 5 seconds, then it returns to the normal screen. 51 DID YOUR DBS RECEIVER CHANGE TO CHANNEL 100? = YES NO PRESS (5,∞), THEN (OK) PRESS (MENU) TO END ● If the DBS receiver's channel does not change as shown above 1 Press SHUTTLE PLUS %fi to move the highlight bar (arrow) to "NO". 2 Press OK. 3 Re-enter the correct code. NOTES: ● The Controller may not work with all types of DBS receiver. ● If your DBS receiver does not respond to the code, you cannot use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording. ● The VCR can only change the satellite channel through the Controller during timer recording. ● If your DBS receiver cannot be operated with a remote control (because it has no remote sensor), you cannot use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording. ● For customers in U.S.A.: If you are unable to set the Controller, contact JVC toll free at 1-800-537-5722.