JVC HR-S5900U Instructions - Page 48

48 EN Edit To Or From Another VCR Connection Ex. When using this VCR as the playback VCR This VCR (for playback) S IN V I D E O CABLE BOX OUT To S VIDEO OUT S-video cable (supplied) To S-video Input REMOTE PAUSE/ AV COMPU -LINK AUDIO VIDEO IN OUT ANTENNA IN R L VHF/UHF TV OUT To AUDIO/ VIDEO OUT Audio/video cable (not supplied) To Audio/ video Input Another VCR (for recording) You can use your VCR as the playback or recording VCR. ● Refer also to the other VCR's instruction manual for 1connection and its operations. Make connections Connect an audio/video cable between the playback VCR's audio/video output connectors and the recording VCR's audio/video input connectors. ● When using this VCR as the recording VCR, connect this VCR's audio/video input connectors to the audio/video output connectors on the other VCR. If the playback VCR is monaural, connect the audio output connector on the playback VCR to the left audio input connector on this VCR. EDITING (cont.) 2 Load cassettes Insert the playback cassette into the playback VCR and the cassette to be recorded on into the 3 recording VCR. Select input mode on recording VCR Select the correct external input on the other VCR. ● On this VCR (when using this VCR as the recording VCR); Select "L-1" - when connecting the other VCR to the audio/video input connectors on the rear panel; Select "F-1" - when connecting the other VCR to the audio/video input connectors on the front panel. On the front panel: Push the JOG dial, then turn it to the left or right. On the Remote: 4 Press the Number key "0 (AUX)" or CH +/-. Select video input terminal on recording VCR When using this VCR as the recording VCR, follow the procedure described on pages 39 and 43. When using S VIDEO terminal, set "FRONT AUX INPUT" (or "REAR AUX INPUT" if you use the connectors on the rear) to "S-VIDEO". When using VIDEO terminal, set "FRONT AUX 5 INPUT" (or "REAR AUX INPUT") to "VIDEO". Select edit mode Set the edit mode to "ON" for the VCRs if such a mode is equipped. ● On this VCR, set "PICTURE CONTROL" to "EDIT" by following the procedure described 6 on pages 39 and 40. Start playback Press PLAY ( 3 ) on the playback VCR. NOTE: If the playback VCR is equipped with a superimpose/ OSD disable feature then set it to "OFF" before starting 7 playback (੬ pg. 39 and 40). Start recording Press REC ( ¶ ) on the recording VCR. NOTE: Be sure to select "AUTO" for "PICTURE CONTROL" (or "NORM" when "VIDEO CALIBRATION" is set to "OFF") after you finish dubbing the tapes (੬ pg. 39 and 40).