JVC HR-S5900U Instructions - Page 36
HR Quick, Programing
UPC - 046838158841
View all JVC HR-S5900U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
36 EN 24HR Quick Programing JOG dial POWER S VIDEO VIDEO (MONO)L-AUDIO-R REC LINK S-VHS ET A.DUB INSERT PLAY REW - FF + CH- /+ PUSH / TURN 24HR QUICK PROGRAM REC PAUSE STOP/EJECT TIMER RECORDING (cont.) You can program a timer recording that starts within 24 hours. Up to 8 timer recording programs can be made as far as a year in advance. Remember, the clock must be set before you can program the timer (੬ pg. 8 1or 10). Load a cassette Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load it into the VCR. ● The VCR turns on, and the counter is reset, 2 automatically. Access 24HR quick program display. Push 24HR QUICK PROGRAM. " " and start time start blinking on the display panel. Program start time indicator 24HR QUICK PROGRAM NOTES: ● If "Err" appears on the display panel, repeat the steps again. ● When a menu screen is shown, you cannot use 24HR quick programing function. Press MENU to return to normal screen, and try again. ● You can use 24HR quick programing function also when the VCR is turned off. ● For 24HR quick programing function, the program overlap warning display does not appear even if some programs overlap each other. ● Even if a power failure occurs, the VCR keeps your timer programs. However, the clock time, channel settings, and other menu settings are lost. As a result, when the power is supplied again to this VCR after the power failure, the following will take place. 1. This VCR starts the Plug & Play setting automatically to restore the clock time and channel setting. 2. If the clock time and channel setting are restored correctly, each timer program you have made will start at its start time unless its end time has elapsed. Timer warning display A warning appears on the TV screen to tell you that the timer-recording is to start in 5 minutes if you are not in the timer -WARNING- TIMER RECORDING TO START SOON (CANCEL) recording standby mode at that time. Press TIMER to put the VCR into timer recording standby mode. To clear the display, press CANCEL on the Remote. 3 Set program start time Turn the JOG dial to the left or right. Then, push the JOG dial. " " and start time start blinking on the display panel. Program start time indicator ● One click stop of the JOG dial changes the 4 time in 5-minute intervals. Set program stop time Turn the JOG dial to the left or right. Then, push the JOG dial and channel number will start blinking. Program stop time indicator ● One click stop of the JOG dial changes the 5 time in 5-minute intervals. Set channel number Turn the JOG dial to the left or right. ● You can cancel the setting at any time by pressing and holding the JOG dial for more 3 than 3 seconds. Repeat from the step . 6 Engage timer recording standby mode Press 24HR QUICK PROGRAM. The VCR turns off automatically and "‰" is displayed on the front display panel.