Kenmore 9757 Use and Care Guide - Page 6

FeetKit,PartNo.279810.

Get Kenmore 9757 - 6.7 cu. Ft. HE2 Gas Dryer PDF manuals and user guides View all Kenmore 9757 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Aleveflloorwithamaximusmlopeof1"(2.5cm)undeer ntire dryer(.Ifslopeisgreatethr an1"[2.5cm],instalEl xtended DryeFr eetKit,PartNo.279810C.)lothems aynottumble properlayndautomatsicensocryclesmaynotoperate correctliyf dryerisnotlevel. Donotoperatyeourdryear ttemperaturbeeslow45°F(7°C)A. t lowetremperaturtehse,dryemr ighnt otshutoffattheendofan automatcicycleD. ryintgimescanbeextended. Thedryermusnt otbeinstalleodrstoredinanareawhereitwill beexposetdowatear nd/owr eather. ChecckoderequiremenStso.mecodeslimito, rdonotpermit, installatioonfthedryeirngaragesc,losetsm, obilehomeso,r sleepinqguarterCs.ontacytourlocabl uildinginspector. NOTEN: oothefruel-burninagppliancceanbeinstalleidnthe samecloseat sa dryer. Installation clearances The location must be large enough to allow the dryer door to open fully. Dryer Dimensions 36" / (61.4 crn) Custom undercounter installation - Dryer only .... 2"* 36" rnin {_"_ "'il I 251c"r*n_ "_""-6287."6--c-r-n_ * Required spacing Closet installation - Dryer only _ 251c"r*n _3"* (7.6 cm) _i 8 in.z* 't Oc2) - 4 irt.2 _ 5crn2) I1"'1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Alevel
floorwithamaximum
slopeof1"(2.5cm)under
entire
dryer.
(Ifslope
isgreater
than1"[2.5cm],
install
Extended
Dryer
FeetKit,PartNo.279810.)
Clothes
maynottumble
properly
andautomatic
sensor
cyclesmaynotoperate
correctly
ifdryer
isnotlevel.
Donotoperate
yourdryer
attemperatures
below45°F
(7°C).
At
lower
temperatures,
thedryer
might
notshutoffattheendofan
automatic
cycle.
Drying
timescanbeextended.
Thedryermust
notbeinstalled
orstored
inanareawhere
itwill
beexposed
towater
and/or
weather.
Check
coderequirements.
Somecodes
limit,
ordonotpermit,
installation
ofthedryer
ingarages,
closets,
mobilehomes,
or
sleeping
quarters.
Contact
your
local
building
inspector.
NOTE:
Noother
fuel-burning
appliance
canbeinstalled
inthe
samecloset
asadryer.
Installation clearances
The location must be large enough to allow the dryer door to
open fully.
Dryer Dimensions
36" /
(61.4
crn)
* Most installations
require a minimum
5" (12.7 cm) clearance
behind the dryer for the exhaust
vent with elbow. See "Venting
Requirements."
Installation
spacing
for recessed
area or closet
installation
The following
spacing
dimensions
are recommended
for this
dryer. This dryer has been tested
for spacing
of 0" (0 cm)
clearance
on the sides and rear. Recommended
spacing
should
be considered
for the following
reasons:
•
Additional
spacing
should
be considered
for ease of
installation
and servicing.
•
Additional
clearances
might be required for wall, door and
floor moldings.
•
Additional
spacing
should
be considered
on all sides of the
dryer to reduce noise transfer.
For closet
installation,
with
a door, minimum
ventilation
openings
in the top and bottom
of the door
are required.
Louvered
doors with
equivalent
ventilation
openings
are
acceptable.
•
Companion
appliance
spacing
should also be considered.
Custom
undercounter
installation
- Dryer only
....
2"*
36"
rnin
{_"_
"'il I
1"* _
"_""-27"----_
_
1"*
25crn
68.6
crn
25crn
* Required spacing
Closet
installation
-
Dryer only
_i
8 in.z*
Oc2) -
4 irt.2
_
5crn2)
I1"'1<-20.66"_'1
s"**l
{2.5cm) (72.77cm) (12.7cm)
A
_3"*
(7.6 cm)
't
-J3,
{7.6 crn)
7
A. Side view
-
closet or confined
area
B. Closet
door with vents
*Required
spacing
**For side or bottom
venting,
0" (0 cm) spacing
is allowed.
Recessed
or closet
installation
-
Dryer on pedestal
(2.5crn)
OO
©
v
_l:_
27"
---}_
(68.6 cm)
A
I;I
H
-<_1"
h"*l*
28.65"
91s"**l
(2.5cm)
(2.5cm)
(72.77cm) (12.7cm)
B
A. Recessed
area
B. Side view
-
closet or confined
area
*Required
spacing
**For side or bottom
venting,
0" (0 cm) spacing
is allowed.