Kenwood DDX9703S User Manual - Page 84
Removing the unit Only for, DDX9903S/DDX9703S/DDX6903S, DDX6703S/DDX9716BTS
View all Kenwood DDX9703S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
CONNECTION/INSTALLATION ❏ Connecting the GPS antenna Connect the GPS antenna (7) to the GPS terminal. • To install the GPS antenna, fix the metal plate (8) firmly on the dashboard, then place the GPS antenna (7) on the metal plate (8). - Clean the dashboard or other surface beforehand. - Install the GPS antenna (7) inside of the car, as horizontally as possible to allow easy reception of the GPS satellite signals. - You can bend the metal plate (8) to conform to a curved surface, if necessary. 7 8 7 • Depending on the type of car, reception of the GPS satellite signals might not be possible with an internal installation. • Install this GPS antenna in an area away from any antennas that are used with CB radios or satellite televisions. • The GPS antenna should be installed at a position at least 30 cm (12 inches) from mobile phone or other transmitting antennas. • The above types of communication may interfere with signals from the GPS satellite. • Painting the GPS antenna with (metallic) paint may cause reduced performance. Removing the unit (Only for DDX9903S/DDX9703S/DDX6903S/ DDX6703S/DDX9716BTS) ❏ Removing the trim plate 1 Engage the catch pins on the extraction key (3) and remove the two locks on the lower part. Lower the frame and pull it forward. 2 2 Remove from the upper two catches. • The frame can be removed from the top side in the same manner. ❏ Removing the unit 1 Remove the trim plate. (See the left column.) 2 Insert the two extraction keys (3), then pull them as illustrated so that the unit can be removed. 3 • Be careful to avoid injury from the catch pins on the extraction key. 3 84