Konica Minolta Kodak i4600 User Guide - Page 30

Installing/Replacing the ink blotter strips, Consumables

Get Konica Minolta Kodak i4600 PDF manuals and user guides View all Konica Minolta Kodak i4600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Installing/Replacing the ink blotter strips The two ink blotter strips, which will be placed in the ink blotter channels at installation, are located in the scanner transport to collect ink overflow. To order additional ink blotter strips, see the section entitled, "Supplies and Consumables" in Chapter 5. 1. Pull the scanner cover release latch forward to release and lift the scanner cover. 2. Locate the two blotter strip channels. These channels are where the blotter strips will be installed or replaced. 3. If you are replacing a blotter strip, proceed with Step 4, if not, go to Step 5. 4. Grasp the blotter strip, carefully pull it off of the channel and discard the soiled strip according to local regulations. 5. Remove the backing from a new blotter strip. 6. Align the blotter strip in one of the channels. A-61651 November 2010 NOTE: Improperly aligned blotter strips may cause document jams. 7. Press the adhesive side of the blotter strip down firmly into the channel. 8. Repeat Steps 4-7 for the other strip. 9. Close the scanner cover. 4-9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
A-61651
November 2010
4-9
Installing/Replacing
the ink blotter strips
The two ink blotter strips, which will be placed in the ink blotter channels at
installation, are located in the scanner transport to collect ink overflow. To
order additional ink blotter strips, see the section entitled, “Supplies and
Consumables” in Chapter 5.
1.
Pull the scanner cover release latch forward to release and lift the scanner
cover.
2.
Locate the two blotter strip channels. These channels are where the blotter
strips will be installed or replaced.
3.
If you are replacing a blotter strip, proceed with Step 4, if not, go to Step 5.
4.
Grasp the blotter strip, carefully pull it off of the channel and discard the
soiled strip according to local regulations.
5.
Remove the backing from a new blotter strip.
6.
Align the blotter strip in one of the channels.
NOTE:
Improperly aligned blotter strips may cause document jams.
7.
Press the adhesive side of the blotter strip down firmly into the channel.
8.
Repeat Steps 4-7 for the other strip.
9.
Close the scanner cover.