Konica Minolta Kodak i4600 User Guide - Page 42

Replacement procedures This section provides procedures for replacing the following parts. Use the list below as a guideline for frequency of replacement. • Feed module tires and separation roller tires - tire life will vary depending upon paper types, environment and cleanliness. Nominal tire life is approximately 600,000 documents; results will vary. Degradation of feeder performance, multiple feeds, stoppages, etc. indicate a need to change tires. Change all the tires on the feed module and separation roller at the same time. • Feed module and separation roller - it is recommended that you install a new feed module and separation roller every 4th tire change. Install a new feed module and separation roller at the same time. • Pre-separation pad - it is recommended that you change the preseparation pad at least as often as you change the feed module/separation roller tires. • Imaging guides - replace when the imaging guides are heavily scratched and defects show in the image. Replacing the feed module or feed module tires 1. Remove the output tray. 2. Lift up and open the printer access cover. NOTE: If you do not want to remove the output tray, you can lift the front of the output tray, then lift the printer access cover and position the printer access cover behind the height adjustment tab. A-61651 November 2010 5-11