Konica Minolta Kodak i4600 User Guide - Page 47
Replacing the imaging guides, Replacing the Flippable White Background strip(s)
View all Konica Minolta Kodak i4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Replacing the imaging guides The imaging guides should be replaced when they are heavily scratched and defects show in the image. NOTE: Handle the imaging guides carefully so as to not put fingerprints on the guides. 1. Open the scanner cover. 2. Loosen the screws on each end of the lower imaging guide and remove it from its position. Replacing the Flippable White Background strip(s) 3. Install the new imaging guide and tighten the screws to secure the imaging guide. 4. Repeat Steps 2 and 3 to replace the upper imaging guide. 5. Close the scanner cover. In the rare case that you may need to replace the Flippable White Background strip(s), follow the procedures below. 1. Open the scanner cover. 2. Loosen the two screws on each end of the lower background strip and remove it from its position. 5-16 3. Disconnect the background strip connector. 4. Connect the new background strip connector with the cable. Be sure it is securely in place. 5. Install the new background strip and tighten both screws on each side to secure the background strip. 6. Repeat Steps 2 - 5 to replace the upper background strip. 7. Close the scanner cover. A-61651 November 2010