Kyocera KM-C1530 Fiery X3e Job Management Guide for Ver 2.0 - Page 56

33-4 Using Command WorkStation Access levels The three possible levels of access to Command WorkStation are Administrator, Operator, and Guest. To enable maximum password protection, Administrator and Operator passwords must be specified in Setup (see the Configuration Guide). When both Administrator and Operator passwords have been specified, the access levels are as follows: Access level Administrator Operator Guest Privileges and password requirements Has full access to all Command WorkStation and Fiery X3e Control Panel functions; Administrator password required. For a description of the full range of tasks an administrator can implement, see the Configuration Guide. Has access to all Command WorkStation functions, except Setup, font management, restarting the Fiery X3e, clearing the Fiery X3e disk, and clearing the Job Log. Operator password required. Can view job status, but cannot make changes to jobs or Setup, and cannot access Job Log; no password required. NOTE: A user may be logged in as Administrator on one Fiery X3e, as Operator on a second Fiery X3e, and as Guest on a third Fiery X3e with Command WorkStation. In these instances, the levels of access are dependent either on the Fiery X3e currently selected in the Active Jobs window or on the Fiery X3e that holds the currently selected job. By default, no passwords are set on the Fiery X3e-in this default state, anyone can perform Setup and use all Command WorkStation functions. Until an Administrator password is defined in Fiery X3e Setup, you can log in to Command WorkStation as an Administrator without entering a password, and you are given full privileges. After the administrator has performed Setup and specified passwords, Command WorkStation user options depend on your login level. This manual assumes that you are logged in to the Fiery X3e as an Operator.