LG 32LD655H Setup Guide - Page 28

Cloning Overview / Clonable Menu Features

Page 28 highlights

Cloning Overview / Clonable Menu Features IMPORTANT CLONING INFORMATION There are three options for cloning a Master TV Setup: • Using a USB memory device • Using a TLL-1100A clone programmer • Using a LT2002 clone programmer Each option is described in further detail on the pages that follow. As you perform cloning procedures, be sure to complete each task as indicated. If a procedure or step is omitted or not performed completely, cloning may not work. At each step, pay attention to ensure the TV screen shows the proper message when cloning. If the message indicated does not appear, there is a problem with that step, and cloning may not be successful. Warning: Copying a blank or incorrect memory into a TV, STB, or other device will cause the TV, STB, or other device to operate erratically or become inoperable. Warning: Do not connect a clone programmer to any PPV card installed in the Master TV or any MPI port while the TV is in PPV Mode, or the clone programmer and the PPV card will be damaged. Before you begin cloning: • Complete the Commercial Mode Setup procedure on pages 13 to 14. • The Master TV EBL must be in Pass-through Mode. • Ensure the Master TV is connected to a good, stable signal source, the TV source selected is Antenna (RF) In, and the signal is from an Aux source or analog (not a digital) channel. • All equipment should be connected to power and turned ON. • Learning and Teaching is only possible between identical model TV/STBs. • Make sure the batteries in the clone programmer, if applicable, are fresh. If batteries are removed, the Clone Clock Time will be lost. • If using a USB memory device, ensure the memory device has been formatted with FAT format. • If using a clone programmer, decide if you want to set the time from the clone programmer or copy the time to the clone programmer from a compatible TV which has the clock set to the current time. Clonable Menu Features Installer Menu Installer Menu item settings Channel Auto Tuning (Channel Lineup) Channel Edit Channel Label Picture Aspect Ratio Picture Mode Advanced Control Audio Auto Volume Clear Voice Sound Mode Balance TV Speaker Option Menu Language Audio Language Caption Caption Mode Digital Caption Options Lock Movie Rating TV Rating - Children TV Rating - General Input Block Time Auto Clock Manual Clock Off Time On Time Auto Off (Sleep Timer) Note: Menu options vary between analog and digital channels and Aux sources. 28 206-4137

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48

28
206-4137
Installer Menu
Installer Menu item settings
Channel
Auto Tuning (Channel Lineup)
Channel Edit
Channel Label
Picture
Aspect Ratio
Picture Mode
Advanced Control
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker
Option
Menu Language
Audio Language
Caption
Caption Mode
Digital Caption Options
Lock
Movie Rating
TV Rating – Children
TV Rating – General
Input Block
Time
Auto Clock
Manual Clock
Off Time
On Time
Auto Off (Sleep Timer)
Cloning Overview / Clonable Menu Features
Note:
Menu options vary between analog and digital channels and Aux sources.
Clonable Menu Features
IMPORTANT CLONING INFORMATION
There are three options for cloning a Master TV Setup:
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each option is described in further detail on the pages that
follow. As you perform cloning procedures, be sure to com-
plete each task as indicated. If a procedure or step is omit-
ted or not performed completely, cloning may not work. At
each step, pay attention to ensure the TV screen shows
the proper message when cloning. If the message indicat-
ed does not appear, there is a problem with that step, and
cloning may not be successful.
Warning: Copying a blank or incorrect memory
into a TV, STB, or other device will cause the TV,
STB, or other device to operate erratically or
become inoperable.
Warning: Do not connect a clone programmer to
any PPV card installed in the Master TV or any
MPI port while the TV is in PPV Mode, or the
clone programmer and the PPV card will be
damaged.
Before you begin cloning:
• Complete the Commercial Mode Setup procedure on
pages 13 to 14.
• The Master TV EBL must be in Pass-through Mode.
• Ensure the Master TV is connected to a good, stable
signal source, the TV source selected is Antenna (RF)
In, and the signal is from an Aux source or analog (not a
digital) channel.
• All equipment should be connected to power and turned
ON.
• Learning and Teaching is only possible between identical
model TV/STBs.
• Make sure the batteries in the clone programmer, if ap-
plicable, are fresh. If batteries are removed, the Clone
Clock Time will be lost.
• If using a USB memory device, ensure the memory de-
vice has been formatted with FAT format.
• If using a clone programmer, decide if you want to set the
time from the clone programmer or copy the time to the
clone programmer from a compatible TV which has the
clock set to the current time.