LG 32LD655H Setup Guide - Page 32

Cloning Procedures (Cont.) Learning / Teaching a Master TV Setup using an LT2002 Clone Programmer Warning: Do not connect a clone programmer to any PPV card installed in the Master TV or any MPI port while the TV is in PPV Mode, or the clone programmer and the PPV card will be damaged. Cloning is accomplished using the TV/ clone programmer MPI ports for communication (see figure). LT2002 Cloning Notes Antenna or CATV • Read the IMPORTANT CLONING INFORMATION on page 28 before beginning any cloning procedures. • A slow flashing green light indicates that there are communication problems between the TV and the LT2002 clone programmer. If this is the case, check for a damaged cable, poor contacts, or other connection troubles. • If the status indicator is red, the LT2002 batteries are low and should be replaced. Install four (4) high-quality alkaline AA batteries. THE CLONE HAS CONTROL OF THE TV THE CLONE IS VERSION XX THE TV IS VERSION XX THE SW IS REViSION XX CLONE CLOCK = XX:XX TV CLOCK = XX:XX - PRESS ANY KEY TO CONTINUE • Teaching and Learning is only possible between identical model TVs/STBs; however, the LT2002 clone programmer can store up to three different Master TV Setups. MPI Cable Ferrite Core (TDK, ZCAT 2035-0930) $POOFDU
DBCMF
UP 57
.1*
+BDL
BOE GPMMPX
PO
TDSFFO instructions Status *OEJDBUPS MPI $PMPS Reset t
HSFFO






CBUUFSZ
PL t
SFE




CBUUFSZ
MPX #MJOL
QBUUFSO t
TMPX







QPXFS
PO no communications t
IFBSUCFBU


QPXFS
PO communications ok LT2002 Clone Programmer ® QuickSet II Programmer LT2002 ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS, USA Learn Setup from Master TV 1. Ensure the Master TV is set up completely and the EBL is in Passthrough Mode. 2. If an analog channel is not available, tune the TV to an Aux source, such as AV-1. Then, plug one end of the MPI cable into the TV MPI port. 3. If there is a good connection after the LT2002 is connected to the TV MPI port, "THE CLONE HAS CONTROL OF THE TV" message will appear on the TV screen. Press any key on the Installer Remote to access the LT2002 Clone Selection Menu. 4. Press 1 on the Installer Remote to select LEARN FROM TV from the Clone Selection Menu; then press ENTER to proceed to the Memory Bank Selection Menu (see sample screen on next page). 5. Select the clone Memory Bank in which to store the Master Setup by pressing either Channel key repeatedly to choose Memory Bank 1, 2, or 3. Note: If you choose a Memory Bank that already has a Master device's setup programmed into it, that setup will be overwritten by the new Master TV Setup. (Continued on next page) THE CLONE HAS CONTROL OF THE TV THE CLONE IS VERSION XX THE TV IS VERSION XX THE SW IS REVISION XX CLONE CLOCK = XX:XX TV CLOCK = XX:XX - PRESS ANY KEY TO CONTINUE. - DISCONNECT CLONE WHEN DONE. CLONE SELECTION MENU (1) LEARN FROM TV (2) TEACH TO TV (3) SET CLONE CLOCK FROM TV (4) SET TV CLOCK FROM CLONE (5) DISPLAY TV SETUP (6) DISPLAY CLONE SETUP - TO CHANGE MENU ITEMS, PRESS CHANNEL KEYS OR DIGITS. - TO EXECUTE ITEM, PRESS ON/OFF, POWER, OR ENTER. 32 206-4137