LG 32LD655H Setup Guide - Page 45
Clone Programmer Troubleshooting
View all LG 32LD655H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Troubleshooting (Cont.) Clone Programmer Troubleshooting Warning: Do not connect a clone programmer to any PPV card installed in the Master TV or any MPI port while the TV is in PPV Mode, or the clone programmer and the PPV card will be damaged. Reset Clone Programmer After Static Shock After replacing exhausted batteries (LT2002 only), or if the clone programmer behaves strangely after a static shock: • TLL-1100A: Turn the TLL-1100A OFF and then ON. • LT2002: Use a paper clip or similar instrument inserted through the small hole marked RESET to activate the internal reset switch and restore normal operation. After a reset, check the real-time clock setting. It may be necessary to reset the clone programmer clock from a TV containing the correct time. Note The TLL-1100A and LT2002 clone programmers are designed to be used with TVs containing the 221-01006 and later processors. Use with earlier TVs may give unpredictable results. Processors used before the 221-01006-04 have a limited screen display capability. They cannot display entire screens as shown in the setup instructions accompanying the clone programmer. Use the printed menu illustrations in the documentation supplied with the clone programmer as an aid to making your programming choices. Symptom Possible Cause(s) Possible Solution(s) Clone Programmer Clone copies setup in less than 30 seconds. Not enough time to copy entire TV setup. Remote does not operate Wrong Installer Remote. clone programmer. Clone menu does not display on TV screen, TLL1100A shows error message, or LT2002 LED does not blink. MPI cord not connected. TV not turned ON. (LT2002 only) Weak batteries. (TLL-1100A only) No charge. Clone menu hard to read. Weak signal. No time set. Time not available. Clone not working. Clone programmer problem. TLL-1100A: Turn the TLL-1100A Off and then ON. LT2002: Press RESET on clone programmer. Then redo Learn/Teach. (Learning usually takes about 90 seconds; Teaching usually takes 3 to 4 minutes.) Only use an LG Installer Remote to operate clone programmer with TV. Connect MPI cord properly, and ensure good connection. TV must be powered ON for clone programmer to work. Install four (4) fresh AA high-quality alkaline batteries. Ensure the TLL-1100A is fully charged or connected to AC power. Connect TV to a reliable analog channel signal source. Set time on a TV, and copy time to clone programmer. Try a different clone programmer. Reset the clone programmer. Clone scans channels more than once. Clone should only scan channels Ensure TV is set up correctly, and try cloning again. once. Master and Target TVs Cloning did not work. (LT2002 only) Clone time disappeared. New setup not present. Procedure interrupted. Different TV models. Step(s) omitted or not performed. Batteries were removed. Target TV not reset. Wait until procedure complete message is displayed. Cloning is only possible with identical model TVs. Refer to the applicable cloning procedure(s), and make sure all tasks were performed. Batteries must remain installed to retain time settings. Disconnect Target TV from AC power for fifteen (15) seconds. • After cloning operations are complete, unplug the TLL-1100A/LT2002 from the TV. • If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels. 206-4137 45