LG LSC121PMA Service Manual - Page 19

Preparing work for Installation

Get LG LSC121PMA PDF manuals and user guides View all LG LSC121PMA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

3) Preparing work for Installation 1. Open panel front s First,Pull the grille bottom, then remove screws(2 pieces), and close grille bottom again. s The moment of lifting the both lower parts of panel front, you can hear sound this panel came out, In this time panel front is separated s After pull down this panel a bit, and separate connecting wire with product. 2. Cover pipe and cover side remove s Remove two screws(for fixing cover pipe) s Pull up the cover side of desired connecting direc- tion, then cover side is separated. s In case connecting direction is left or right, path through the hole of cover side. CAUTION After removing the pipe hole, cut the burr for safety. Panel Front Connector Pipe hole When connecting pipe path through rear wall, don't remove the hole. 3. Drain hose junction s Remove the rubber stopple of desired drain direc- tion. s As the following picture, Insert drain hose in the handle of drain pan, and join drain hose and connecting hose. -19- Adhesive Only one desiring direction Connecting part Drain hose rubber cap

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
-19-
1. Open panel front
■
First,Pull the grille bottom, then remove screws(2
pieces), and close grille bottom again.
■
The moment of lifting the both lower parts of panel
front, you can hear sound this panel came out, In
this time panel front is separated
■
After pull down this panel a bit, and separate con-
necting wire with product.
Pipe hole
Panel Front
Connector
2. Cover pipe and cover side remove
■
Remove two screws(for fixing cover pipe)
■
Pull up the cover side of desired connecting direc-
tion, then cover side is separated.
■
In case connecting direction is left or right, path
through the hole of cover side.
When connecting pipe path through rear wall, don’t
remove the hole.
3. Drain hose junction
■
Remove the rubber stopple of desired drain direc-
tion.
■
As the following picture, Insert drain hose in the
handle of drain pan, and join drain hose and con-
necting hose.
rubber cap
Only one
desiring direction
Connecting
part
Adhesive
Drain
hose
3) Preparing work for Installation
After removing the pipe hole, cut the burr for safety.
CAUTION