LG WM3460CW Owners Manual - Page 47

Error Codes

Page 47 highlights

Error Codes TROUBLESHOOTING 47 ENGLISH Problem Washer fills with water slowly or not at all, or The tub does not rotate or Possible Cause Solutions Water supply faucets are not fully ••Make sure that the water faucets are fully open. open. Water line hoses are kinked, pinched, or crushed. ••Make sure that the hoses are not kinked or pinched. Be careful when moving the washer during cleaning and maintenance. Water inlet filters are clogged. ••Clean the inlet filters. See the Maintenance section. Water supply pressure to faucet or house is too low. ••Check another faucet in the house to make sure that household water pressure is adequate and flow is not restricted. Disconnect the inlet hose from the washer and run a few gallons of water through the hose to flush the water supply lines. If flow is too low, contact a plumber to have the water lines repaired. Water supply connected with leaklimiting hoses. ••Hoses designed to limit leaks can trip falsely and prevent the washer from filling. The use of leaklimiting hoses is not recommended. If the balance is not successful, this error will be displayed. ••The automatic attempt to rebalance the load was not successful. The cycle has been paused to allow the load to be manually adjusted. The load is too small. ••Small loads may need additional items to be added to allow the washer to balance the loads. Heavy articles are mixed with lighter items. ••The load may have heavy items loaded with lighter items. Always try to wash articles of somewhat similar weight to allow the washer to evenly distribute the weight of the load for spinning. The load is out of balance. ••Manually redistribute the load if articles have become tangled, preventing the automatic distribution from working properly. The load contains pillows or cushions. ••Wash the covers only. Remove the stuffing from the pillows or cushions before washing the covers. The door is not secured. ••Close and secure the door. If the message keeps appearing, unplug the power cord and call for service.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167

47
TROUBLESHOOTING
ENGLISH
Error Codes
Problem
Possible Cause
Solutions
Washer fills with water
slowly or not at all, or
Water supply faucets are not fully
open.
Make sure that the water faucets are fully
open.
Water line hoses are kinked,
pinched, or crushed.
Make sure that the hoses are not kinked or
pinched. Be careful when moving the washer
during cleaning and maintenance.
Water inlet filters are clogged.
Clean the inlet filters. See the Maintenance
section.
Water supply pressure to faucet or
house is too low.
Check another faucet in the house to
make
sure that household water pressure
is adequate and flow is not restricted.
Disconnect the inlet hose from the washer
and run a few gallons of water through the
hose to flush the water supply lines. If flow is
too low, contact a plumber to have the water
lines repaired.
Water supply connected with
leaklimiting hoses.
Hoses designed to limit leaks can trip falsely
and prevent the washer from filling. The use
of leaklimiting hoses is not recommended.
If the balance is not successful,
this error will be displayed.
The automatic attempt to rebalance the load
was not successful. The cycle has been
paused to allow the load to be manually
adjusted.
The load is too small.
Small loads may need additional items to be
added to allow the washer to balance the
loads.
Heavy articles are mixed with
lighter items.
The load may have heavy items loaded with
lighter items. Always try to wash articles of
somewhat similar weight to allow the washer
to evenly distribute the weight of the load for
spinning.
The load is out of balance.
Manually redistribute the load if articles have
become tangled, preventing the automatic
distribution from working properly.
The load contains pillows or
cushions.
Wash the covers only. Remove the stuffing
from the pillows or cushions before washing
the covers.
The tub does not rotate
or
The door is not secured.
Close and secure the door. If the message
keeps appearing, unplug the power cord and
call for service.