Lenovo ThinkCentre M57 Hardware Maintenance Manual - Page 76
Replacing the microprocessor
View all Lenovo ThinkCentre M57 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
4. Install the new battery. 5. Close the computer cover, and connect all the cables. See "Completing the FRU replacement" on page 81. Note: When the computer is turned on for the first time after battery replacement, an error message might be displayed. This is normal after replacing the battery. 6. Turn on the computer and all attached devices. 7. Use the Setup Utility program to set the date and time and any passwords. See Chapter 6 "Diagnostics, Test and Recovery Information" on page 39. Replacing the microprocessor This section provides instructions on how to replace the microprocessor. 1. Open the computer cover. See "Opening the cover" on page 68. 2. Locate the microprocessor. See "System board locations" on page 68. 3. Remove the four screws securing the heat sink to the retention module on the system board and lift the heat sink off the system board. 4. Disengage the microprocessor from the system board socket by pivoting the small handle upward until it is in the vertical position. 5. Lift the microprocessor straight up and out of the socket. 70 Hardware Maintenance Manual