Lexmark 1200 Setup Guide - Page 51
Installing a harddisk, Attaching an, adapter ribbon cable
UPC - 734646167000
View all Lexmark 1200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Installing a hard disk Two hard disk options are available from Lexmark: • A hard disk with a ribbon cable already installed. • An adapter ribbon cable alone that you can use to install any other Lexmark or third-party hard disk meeting the following criteria: - 2.5-inch platter - ATA-2 (IDE) interface - Maximum thickness of 13 mm (.51 in.) Attaching an adapter ribbon cable If you bought an adapter ribbon cable for a separate hard disk, follow these instructions to attach the cable to the disk. If your disk already has a ribbon cable attached, skip to "Installing the disk" on page 46. The adapter ribbon cable comes with screws for securing the hard disk to the system board. Stripe 1 Locate the 47-hole connector on the ribbon cable. One of the 50-hole connectors has three holes plugged. 2 Carefully attach the 47-hole connector to the disk connector. When correctly installed, the stripe on the ribbon cable should be oriented as shown. 3 Continue with "Installing the disk" on page 46. Install memory and network options 45