Lexmark 30G0109 User Manual - Page 161

Waiting The printer has received data to print, but is waiting for an End-of-Job command, a Form Feed command, or additional data. Try one or more of the following: • Press to print the contents of the buffer. • Cancel the current print job. 30 Invalid refill, change cartridge Remove the print cartridge, and then install a supported one. 31 Replace defective cartridge Remove the defective print cartridge, and then install a new one. 32 Cartridge part number unsupported by device Remove the print cartridge, and then install a supported one. 34 Short paper Try one or more of the following: • Load the appropriate paper in the tray. • Press the arrow buttons until Continue appears, and then press to clear the message and print the job using a different paper tray. • Check tray length and width guides and make sure the paper is properly loaded in the tray. • For Windows users, check the Print Properties settings to make sure the print job is requesting the correct paper size and type. For Macintosh users, check the Print dialog settings to make sure the print job is requesting the correct paper size and type. • Check that the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, make sure the paper is large enough for the data being printed. • Cancel the current print job. 35 Insufficient memory to support Resource Save feature Try one or more of the following: • Press the arrow buttons until Continue appears, and then press to disable Resource Save and continue printing. • To enable Resource Save after receiving this message, make sure the link buffers are set to Auto, and then exit the menus to activate the link buffer changes. When Ready appears, enable Resource Save. • Install additional memory. Understanding printer messages 161