Lexmark MX711 User's Guide - Page 282

Troubleshooting 282 Replace separator pad Try one or more of the following: • Replace the separator pad. For more information, see the instruction sheet that came with the supply. • From the printer control panel, touch Ignore to clear the message. Replace unsupported cartridge [32.xy] Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's Guide. Note: If you do not have a replacement cartridge, then see the "Ordering supplies" section of the User's Guide or visit www.lexmark.com. Replace unsupported imaging unit [32.xy] Remove the imaging unit, and then install a supported one to clear the message and continue printing. For more information, see the instruction sheet that came with the supply or see the "Replacing supplies" section of the User's Guide. Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section of the User's Guide or visit www.lexmark.com. Replace wiper Try one or more of the following: • Replace the fuser wiper in the printer. • Touch Continue to clear the message and continue printing. Restore held jobs? Try one or more of the following: • From the printer control panel, touch Restore to restore all held jobs stored in the printer hard disk. • From the printer control panel, touch Do not restore if you do not want to restore any of the print jobs. Scan document too long The scan job exceeds the maximum number of pages. Touch Cancel job to clear the message and cancel the scan job. Scanner automatic feeder cover open Close the ADF cover. Scanner disabled by admin [840.01] Print without the scanner, or contact your system support person.