Lexmark Optra S Service Manual - Page 120
Inspect the HVPS PC drum, Front Cable Harness
View all Lexmark Optra S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
4059-XXX FRU 2 High Voltage Contact 3 HVPS 4 Front Cable Harness HVPS Section 5 Printhead Assembly Action Check the PC drum contact on the right side frame for damage, PC drum contact wear or contamination. If the contact is bent or damaged, replace the contact. Note: Inspect the HVPS PC drum contact on the board for any signs of damage or contamination. Check the fuse on the HVPS. If open, replace the HVPS. Check the voltages at J10 on the engine board. Measure the following voltages from connector J10 to printer ground: Printer Idle J10-5 measures +24 V dc Printer Printing J10-5 measures +24 V dc In the voltages at J10-5 are incorrect, replace the engine board. Check the front cable harness at J10 on the engine board and at CN1 on the HVPS to make sure the harness is connected properly. If connected properly, check the continuity of the cable harness. If there is no continuity, replace the front cable harness. Generally a 93x service error is posted if the printhead assembly fails and the printer does not give a blank copy symptom. The printhead used in the printer does not have a mechanical shutter as previous laser printers. The printer is interlocked through the front top cover interlock switch. 2-93 4059 Service Manual