Lexmark Optra S Service Manual - Page 35

4059-XXX Base Printer Sub Error Codes Each status byte has a different level of troubleshooting value for each area of the printer. The following table displays status bytes 1, 2 and 3. This set of status bytes is designed to help isolate paper jams and paper feed problems in the base printer. Status Bytes 1, 2,3 Explanation 84 xx 00 84 xx 01 84 xx 02 84 xx 04 84 xx 05 84 xx 06 84 xx 07 84 xx 08 84 xx 09 The input sensor is still covered by the first sheet of paper through the printer and the second sheet is ready to arrive at the sensor. Video information has not started on the page at the input sensor within two inches after activating the input sensor flag. The media takes too long to complete a pass through the input sensor. This can occur when a sheet of paper is in the machine during POST and the input sensor flag has tripped the input sensor. This error is generated whenever media is seen at the input sensor before the sensor flag activates the input sensor. A paper jam is detected by the tray you are trying to feed from. A paper jam is detected by a smart option and an error message displays. Paper Tray 5 pass thru sensor is not activated by a sheet of paper. Paper Tray 4 pass thru sensor is not activated by a sheet of paper. 84 xx 0A 84 xx 0B 84 xx 0C Paper Tray 3 pass thru sensor is not activated by a sheet of paper. Paper Tray 2 pass thru sensor is not activated by a sheet of paper. Paper Tray 5 pass thru sensor is not activated and never deactivated. A sheet of paper may still be over the sensor or the flag is still activated. Diagnostic Information 2-8